How To Crimp Pex Without Tool

How to brand a PEX Cinch/Clamp connection in 6 easy steps

Tools and materials required:

1. PEX tubing
2. PEX cutter tool
3. Brass or Poly PEX crimp plumbing fixtures(s)
4. PEX sure-fire clamps
5. PEX cinch/clamp tool

Safe showtime - always wear appropriate heart protection gear.

Stride 1:

Position the cutter perpendicular to the PEX pipe and make a polish, clean cutting.

Step 2:

Slide the PEX cinch clamp over the pipe.

Step 3:

Fully insert the PEX crimp fitting into the pipe.

Stride iv:

Slide the cinch clamp toward the plumbing fixtures so that information technology (edge of the clench closest to the fitting) is positioned 1/8" – one/4" from the end of the piping.

Footstep 5:

First, fully close the PEX cinch tool, so that the ratchet mechanism would release the jaws. Second, position the open up jaws of the tool over the ear of the cinch clamp as shown.

Step 6:

Fully close the jaws of the tool. Ratchet mechanism volition prevent early release and will not allow to open the tool until the connection is complete.

Connection is consummate

A typical example of a completed connection is shown below. Always inspect information technology visually to confirm that the plumbing fixtures is fully inserted and clench's edge within the acceptable distance from the pipe'due south end.

Ofttimes Asked Questions:

Q: Are fittings removable/reusable?
A: Yes. To remove the fitting, utilise wire cutters to cut off the ear of the clamp and pry the remaining portion with a flatbed screwdriver. After the clench is removed, the fitting can be pulled out with a little effort.

Q: Which type of fittings and pipe can sure-fire method be used with?
A: Cinch/clamp method works with crimp style brass or poly PEX fittings (poly PEX fittings shown in this tutorial) and with all types of PEX tubing (bulwark and non-barrier, whether A, B or C types). This method is not uniform with PEX-AL-PEX tubing.

Q: Which brand cinch clamps do you lot recommend?
A: Nosotros recommend

but

the Oetiker brand PEX clamps – these have the best quality (material blazon, strength and thickness) among all we've tested and they are the just NSF certified clamps on the market. In addition, these clamps accept just the proper amount of lubricant sprayed on the inside (non exterior) surface of the band (clamp) which allows it to evenly compress over the pipe'south surface, effectively distributing the force without over-stressing individual points.

Q: Which is meliorate – clench or crimp method?
A: We sell almost an equal corporeality of crimp rings and cinch clamps. Clamps are growing in popularity since they are easier to install and the PEX sure-fire tool is more than compact then the crimp 1, allowing to make connexion in less accessible locations. In add-on, cinch tool is universal and works with all clench sizes, whereas crimp method requires a divide tool (or a change or tool jaws) for every PEX tubing size. However, crimp method offers a somewhat more uniform and hands judge-able connection, and has decades of proven functioning, which makes is a popular pick amidst professionals and DIY'ers alike.

Q: Is there a gauge tool for the cinch clamps?
A: PEX cinch/clamp tools sold at PexUniverse are factory-calibrated and do not require initial aligning. To bank check whether the tool is properly calibrated, use a depth gauge. The jaw opening of the tool in a fully closed position should be between 0.8-i.2mm.
Meet picture for reference.

Source: https://www.pexuniverse.com/how-make-pex-cinchclamp-connection-6-easy-steps

Share this post